BlueRay Sting™ Features
Reports alarms to 4 Mobile phones
Solid state movement alarm
Two external sensor zones
One external warning input
Alarm output to drive siren/strobe
Low power consumption (less than 5ma*)
Designed for the marine environment
GPS lat, long, speed & direction option
GeoFence alarm with GPS option
Protect trailer boats and smaller yachts
When on land monitor for movement using the integrated detector. When on the water monitor for trespassers, break in and sinking. Add GPS for geo fence protection and exact location reporting.
Alarms
The 2 sensor inputs on the BlueRay Sting system are surge protected resistive loop circuits designed to operate with normally open and normally closed sensors. These can be passive sensors such as; reed switches, floor pressure mats and dinghy switch to protect hatches, doors, walkways and dinghies. , The system also supports active sensors such as motion detectors, proximity detectors, beam sensors and under deck/floor stress sensors to protect larger cabin spaces, deck areas and outdoor walkways. Each alarm may be isolated individually. For example this allows a boat that is normally kept on a trailer to be put on a mooring by isolating the inertia sensor but leaving Geo-fence on.
Warnings
The Sting includes one warning input for bilge monitoring. The system also monitors the boats battery and will send warning messages if the boat battery voltage becomes low.
Messages
Alarm and warning messages are sent directly to the chosen mobile phones. Up to 4 mobile phones may be programmed into the system to receive messages. The system can operate with or without a monitoring service and therefore ongoing monitoring fees are not required unless a service is selected.
* BlueRay Sting system with standard wakeup periods. Note: Wakeup times and active sensors can increase power consumption.
BlueRay Manta™ Features
5 alarm zones, multiple sensor capability
3 warning zones for bilge and shore power
Reports alarms to 6 mobile phones
Optional alert to a standard telephone
Fully customizable SMS alarm messages
Automatic cabin/deck light activation
Remote system diagnostics
Remote sensor isolation and activation
Remote control of electrical equipment
Operates on 12 or 24 Volt Systems Monitors and reports low battery voltage
Low power consumption (less than 6ma*)
Designed for the marine environment
Protection for Yachts and Power Cruisers
Protection for yachts, motor cruisers, ferries and commercial vessels. The BlueRay Manta™ system monitors bilges, batteries, shore power and boat security delivering alarm messages directly to multiple mobile phones for immediate action.
Alarms
The BlueRay Marine Manta system all include 5 independent alarm zones and 3 warning zones. The warning circuits are described below. The 5 alarm zones are surge protected resistive loop circuits designed to operate with normally open and normally closed sensors. These can be passive sensors such as; heavy duty reed switches, floor pressure mats and proximity switches to protect hatches, doors, walkways and dinghies. , The system also supports active sensors such as dual technology motion detectors, floor pressure detectors and beam sensors to protect larger cabin spaces, deck areas and outdoor walkways.
Multiple sensors may be fitted to each alarm zone enabling larger vessels to be protected. Each sensor alarm may be custom named. See programming for more details.
Individual alarm circuits can be programmed to trip instantly or as a preset delay. Faulty sensors may also be remotely isolated while leaving the the remainder of the system operational.
Alarm zones can be wired to automatically turn on the cabin/deck lights when tripped. This is intended as a courtesy function for the owner boarding at night however it also serves to illuminate potential thieves.
Once an alarm is triggered the local siren is switched on and the alarm message sent to all listed mobile phones.
Bilge and Warnings
In addition to low and very low battery warnings the system is capable of monitoring 3 separate warning zones. These are surge protected level sensitive inputs and are designed to monitor bilges, smoke detectors or shore power connections. Special functionality is included for warning inputs. The owner will receive periodic warnings that the alert is still current. Warning alerts do not trigger the alarm siren but do send alert messages to all mobile phones on the systems list (when the system is armed) .
Remote Control
The system may be disarmed remotely using a text message from one of the authorised mobile phones. BlueRay Manta Plus systems may also be remotely armed. The system, in addition to controlling the alarm siren and cabin/deck lights, can control other electrical devices. These include remotely turning on or off fridges, air-conditioning or heating.
Messages
Alarm and warning messages are sent directly to the chosen mobile phones. There is no requirement for a monitoring service and therefore no ongoing monitoring fees. All that the customer pays for is the text messages from the boat and any monthly SIM charges. (Customers with high mobile phone spend rates can negotiate additional SIM's bundled at no additional monthly charge.)
Alarm and warning messages are fully customisable using simple programming commands and are used to uniquely name each alarm circuit. Multiple language characters are supported. (Programming is performed using a mobile phone and text messages.)
~ Subject to mobile provider supplying standard cell information.
